I have a working cimplicity 8.1 system monitoring tank levels.
I installed a secondary pc to the system so they can be viewed from two locations.
Was able to install cimplicity and copy my project over and can run with no issues.
Except I do not get a value on 8 of my 37 tanks?
When I connect my original pc I can see the proper tank levels.
I have yet to connect them thru a switch have left all the original wiring in place and am only swapping the LAN cable over till I get my setup correct.
I have compared the point ref from the working points and non working points and everything looks set.
When I go into my point control panel can see the time stamp of the non working points does not update like the working points.
Pretty new with cimplicity so could be something basic I am missing.
I installed a secondary pc to the system so they can be viewed from two locations.
Was able to install cimplicity and copy my project over and can run with no issues.
Except I do not get a value on 8 of my 37 tanks?
When I connect my original pc I can see the proper tank levels.
I have yet to connect them thru a switch have left all the original wiring in place and am only swapping the LAN cable over till I get my setup correct.
I have compared the point ref from the working points and non working points and everything looks set.
When I go into my point control panel can see the time stamp of the non working points does not update like the working points.
Pretty new with cimplicity so could be something basic I am missing.