bob_pgh
Member
Hello everyone. I was hoping someone could help me out or point me in the right direction in regards to using CitectSCADA with the WAGO 750-841.
I have successfully configured the Citect software with my IO device. I have set up IO device and downloaded the application to the device that has quite a few output variables that I would like to show in Citect.
The problem that I seem to be having is the following:
To just do a test, I created a variable tag in Citect that has the following configuration:
variable tag name: total
cluster name: test_cluster
i/o device name: wago_io
address: 40001
data type: digital
So then I set up a simple text box on the page that references this variable tag.
The problem I am getting is I would like it to show the count that is stored in the output variable in the WAGO controller and not just a 1 or a 0. It shows a 1, when I have 24V on the 1st module, 1st input.
How can I get the Citect software to show the total instead of just 1 or 0?
Thank you in advance.
I have successfully configured the Citect software with my IO device. I have set up IO device and downloaded the application to the device that has quite a few output variables that I would like to show in Citect.
The problem that I seem to be having is the following:
To just do a test, I created a variable tag in Citect that has the following configuration:
variable tag name: total
cluster name: test_cluster
i/o device name: wago_io
address: 40001
data type: digital
So then I set up a simple text box on the page that references this variable tag.
The problem I am getting is I would like it to show the count that is stored in the output variable in the WAGO controller and not just a 1 or a 0. It shows a 1, when I have 24V on the 1st module, 1st input.
How can I get the Citect software to show the total instead of just 1 or 0?
Thank you in advance.