Daine Atkins
Member
Hi All.
Please could I get some assistance. I have been battling with an Omron PLC.
Trying to get analogue I/O to work using a CJ2M-CPU12 and CX-Programmer.
I have a CJ1W-MAD42 4 In and 2 Out. Everything on the machine is 0-10V.
I have done all the scaling and setup in the IO Table and checked the dip switches on the card but I am just not having any luck.
Not sure if I am using the correct addressing but according to the datasheet, it is correct.
Please help.
Please could I get some assistance. I have been battling with an Omron PLC.
Trying to get analogue I/O to work using a CJ2M-CPU12 and CX-Programmer.
I have a CJ1W-MAD42 4 In and 2 Out. Everything on the machine is 0-10V.
I have done all the scaling and setup in the IO Table and checked the dip switches on the card but I am just not having any luck.
Not sure if I am using the correct addressing but according to the datasheet, it is correct.
Please help.