rgmiles
Member
I have a cj1m cpu11 etn plc and wish to conect it to a network using ethernet.
I am new to networking i have only used plc's for control to this point and need some help.
I have connected the plc to the network the plc address is set to default.
the network says it is connected , but i cannot Ping the plc.
i have read the manual inside out but i seem to be missing something.
Can anyone point me in the right direction?Sample settings etc?
Regards.
Bob
I am new to networking i have only used plc's for control to this point and need some help.
I have connected the plc to the network the plc address is set to default.
the network says it is connected , but i cannot Ping the plc.
i have read the manual inside out but i seem to be missing something.
Can anyone point me in the right direction?Sample settings etc?
Regards.
Bob