Hi,
im trying to build wood-mill cnc. I have 3 ULTRA 100 controllers, N-3412-2-H00AA and Motherboard CNC - SSK-MB2
I connected this set to PC and when i run it under Mach3 software (demo).
Problem is that when i change rotation direction, receive fault on ULtra 100 : "master encoder fault state"
One direction is OK, change = error.
Any suggestions ?
Sorry for my pure English.
regards
Bartek
P.S. Under "Ultra Master" software error doesn't appear.
im trying to build wood-mill cnc. I have 3 ULTRA 100 controllers, N-3412-2-H00AA and Motherboard CNC - SSK-MB2
I connected this set to PC and when i run it under Mach3 software (demo).
Problem is that when i change rotation direction, receive fault on ULtra 100 : "master encoder fault state"
One direction is OK, change = error.
Any suggestions ?
Sorry for my pure English.
regards
Bartek
P.S. Under "Ultra Master" software error doesn't appear.