All
Found myself in a situation where I need to flash the 1769_sdn Devicenet module from 2.002 to 4.004. I uploaded from the module but it has been a few years and did not upload from each device on the network. So when I down loaded after flashing, the modules showed up on the network but no config data in the modules. So My supervisor had Spread sheets with all the setup data and we plugged it in by hand. Everything went fine except 2 encoder modules in a
remote point I/O rack. It would only let us set bit length to 48 when we had
92 Before and it only had COS as a message selection and we needed it set to polled. Anyone got some help for me here? Much appreciated! We had to bail and go back to the 2.002 ver.
Found myself in a situation where I need to flash the 1769_sdn Devicenet module from 2.002 to 4.004. I uploaded from the module but it has been a few years and did not upload from each device on the network. So when I down loaded after flashing, the modules showed up on the network but no config data in the modules. So My supervisor had Spread sheets with all the setup data and we plugged it in by hand. Everything went fine except 2 encoder modules in a
remote point I/O rack. It would only let us set bit length to 48 when we had
92 Before and it only had COS as a message selection and we needed it set to polled. Anyone got some help for me here? Much appreciated! We had to bail and go back to the 2.002 ver.