Trying to configure the 2nd drive on this machine. It is being
difficult. I have the gains speed encoder data all with good data. when I try to
run the tune function it says it can't complete the test, speed is too low.
I have it set to the max speed. Any Ideas. Also if I try to run it with
current data it faults on F19.
difficult. I have the gains speed encoder data all with good data. when I try to
run the tune function it says it can't complete the test, speed is too low.
I have it set to the max speed. Any Ideas. Also if I try to run it with
current data it faults on F19.