Concept 2.6XL Warnings

totallychibi

Member
T
Join Date
Oct 2005
Location
CI
Posts
5
This is my first time using Concept. When analysing the sections from Project / Analyse Section, or Program, I get the following Warnings.

Warning: Address overlap; variable 'ERD01R01S08' AT %300009 and variable 'ER1BN01LT01_RAW' AT %300001
Warning: Address overlap; variable 'ERD01R01S09' AT %300018 and variable 'ER1CR01LU01PT01_RAW' AT %300010
Warning: Address overlap; variable 'ERD01R01S10' AT %300027 and variable 'ER1CR01TT01_RAW' AT %300019
Warning: Address overlap; variable 'ERD01R01S03' AT %300054 and variable 'ER1CV555LT01_RAW' AT %300048

there are 12 of these messages. I am not sure what this means. How do I fix this?
 

Similar Topics

J
Unity Pro & Concept 2.6XL System Bits
Hi All, I have a job to make a diagnostic program to M340 and Momentum(two job same logic), M340 program done but momentum plc was facing program...
Replies
0
Views
1,839
jin1016
J
isometric
Concept 2.6XL error connecting to Quantum PLC
Hi all, Recently, I have an issue with Concept 2.6XL SR2 connecting to Quantum PLC. I can only connect in "Monitor only" mode. When I tried to...
Replies
4
Views
4,267
Joseph Talin
J
A
Help Networking Two 171 CCC 960 30-IEC for Distributed I/O in Concept 2.6XL SR-7
Hello, I have to network two 171 CCC 960 30-IEC PLCs together for a project. I cannot seem to find any information as to how to do this. I have...
Replies
0
Views
1,996
agentnumber2
A
F
Schneider Concept 2.6 programming for momentum PLC
Trying to identify the Modbus RTU registers that are in use in the Function block programming in the PLC program. I have a Kohler DEC 550...
Replies
0
Views
188
Fets1
F
F
Weight Feeder Concept
I'm just starting to learn about industrial automation processes, I want to know how a weight feeder unit works which consists of a load cell and...
Replies
14
Views
1,134
padees
P
Back
Top Bottom