wa5yom
Member
I have a ControlLogix configured with 2 PanelView Plus 6's two individual DLR networks.
1 DLR Network has 5 Armorstart drives.
The other DLR Network is a combination of Point IO and Armorpoint IO.
There is also some local IO.
Upon a cold start (turning on the main disconnect), the processor always has a major fault.
Fault Code 23, "At least one required connection was not established before going into run mode."
This is not intermittent.
Upon clearing the fault....everything works fine.
Any ideas?
Thanks,
Tim
1 DLR Network has 5 Armorstart drives.
The other DLR Network is a combination of Point IO and Armorpoint IO.
There is also some local IO.
Upon a cold start (turning on the main disconnect), the processor always has a major fault.
Fault Code 23, "At least one required connection was not established before going into run mode."
This is not intermittent.
Upon clearing the fault....everything works fine.
Any ideas?
Thanks,
Tim
Last edited: