skywalker309
Member
Hi. I´m trying to upgrade some machines in my plant. I want to change some SLC100 and SLC150 into SLC500 or Micrologix. Is there a way to convert the program? Or do I have to write the program once again? Thanks.
Convert SLC100/150 to SLC500
- Thread starter skywalker309
- Start date
TConnolly
Lifetime Supporting Member
Unfortunately, you'll have to do the conversion by hand. There isn't a conversion utility.
I suggest you use a Micrologix - it will fit the footprint better, and they cost considerably less.
I suggest you use a Micrologix - it will fit the footprint better, and they cost considerably less.
skywalker309
Member
OP
Well, I'll do it that way, thanks.
Similar Topics
Hello all,
I'm currently working on a servo motor linear positioning system (ball screw). I'm all set up regarding communication between my HMI...
I have an application using an incremental encoder and then I convert it to degree (0-360) using calculation program. For a while, the calculation...
Hi all. Me again still learning Rockwell.
So I'll be polling an INT data array from a Modbus SE power meter with a L82 (with a Modbus ProSoft in...
Hello, could someone kindly convert the attached RSP files that are currently used for SLC 5 PLC into PDF please
I'm trying to convert an RS Logix 500 fille when I open the 500 file and try to "save as" a .slc file, it does not allow it. It says " SLC library...