any out there have any information on converting seimens s5 to allen bradley slc500 as i am looking at converting these programs in our plant. any info on this subject i would be very gratefull
I doubt it very much if there is any programs out there that will do this for you, so you will have to do it all manually. In other words, re-write the whole lot to suit the SLC500.
PLucas wrote:
I doubt it very much if there is any programs out there that will do this for you, so you will have to do it all manually. In other words, re-write the whole lot to suit the SLC500.
Well, Paul, that's correct. I'm teaching both S5 and SLC500. In both courses I'm using similar or even equal project examples. While writing those courses I have been looking for a translation tool and I came up with nothing.
JesperMP wrote:
The bad new is, that not everything can be viewed/printed as LAD.
Well, if you're using STEP5 version 6 or higher, there's a lot more that can be represented in ladder than in versions 5 and lower. It's however not more than about 90%.