Ronnie Sullivan
Member
I am converting a Toshiba T-1 ladder program to an Mitsubishi FX3
All is going well - nothing too complicated apart from an SS timer.
The T-1 uses inline timers so I have to seperate them out and used the 'done' bit to continue the line.
I have come across lots of 2 timers inline, one of them being an SS timer
In the manual SS stands for single shot
But I can't see how they work?
the line is like this
I can understand that when the n/o contact closes T16 times out then starts T17 but these timers are inline to operate output Y002E
How does the single shot work - and even why have 2 timers in series for just one output?
All is going well - nothing too complicated apart from an SS timer.
The T-1 uses inline timers so I have to seperate them out and used the 'done' bit to continue the line.
I have come across lots of 2 timers inline, one of them being an SS timer
In the manual SS stands for single shot
But I can't see how they work?
the line is like this
Code:
! !--[0640 TON T16] [00200 SS T17]------Y002E-!
I can understand that when the n/o contact closes T16 times out then starts T17 but these timers are inline to operate output Y002E
How does the single shot work - and even why have 2 timers in series for just one output?