CP1430 NOT SYNCHRONIZED status

[gustavo_dias]

Hi experts,


I have a CP1430TF and he still with not synchronized status. I need to configure it for communication with step7. I configure the both like this link and my OB20, 21 and 22 at the S5 side is like the attachment.


My CP is in slot 8 in rack (I start to count at 1). My CPU is 928B.


I reaaly don't know how to proceed with this

 

[sigmadelta]

Why did you change the BLGR to 6 instead of 255?

 

[gustavo_dias]

I was trying another configs, I saw it in manual

 

[sigmadelta]

Try 255.

 

[gustavo_dias]

Don't work

 

[sigmadelta]

try to stop and start the CPU by STEP5 and not the switch on the CPU

 

[gustavo_dias]

Don't work again. I already did it with CP. May the problem is in rack position of CP and CPU, I change all SSNR config in OB's and FB's. My CPU is in Slot 3 and CP in slot 4. I don't have I/O cards and my rack is 21 slots.

My doubt is about slot number, I start of slot 0 or slot 1?

 

[sigmadelta]

what is the part # of your rack?

 

[sigmadelta]

Actually, nevermind... across the top of the modules... do you see a label strip with numbers (example: 3, 11, 19, 27....). Under which number is your CP slotted?

 

[gustavo_dias]

Sorry, I don't understand what "#" means. If is about the code number is: 6ES5188-3UA12

 

[sigmadelta]

The SSNR number should be whatever you set it to be in the COM 1430 TF.

 

[gustavo_dias]

Yes, but if the real CP is not in SSNR config in software i have an error... Or not?

 

[sigmadelta]

no.. I believe you can set the SSNR to be whatever you want, as long as another module in the rack does not have the same SSNR number. You set the SSNR number in the COM1430TF, and use the same number in the SYNCHRON block.

 

[gustavo_dias]

Yes, this is what I do, but my problem still

 

[sigmadelta]

STOP AND START the CP in COM1430TF?