CP5611 under Windows XP
- Thread starter szpachel
- Start date
Migrate
Hi,
We'll start a test to install a wincc v4 project on an win2000 application (this is possible for wincc v5).
For an upgrade from Wincc ver. 4 to ver. 6 you'll first need to migrate to v. 5.1 SP2, then you'll need to update the Sysbase en then migrate to ver. 6 and higher. Is migration a good option in this case??? New software??? Hmmmmm....choises.
After the test I'll post the results.
Hi,
We'll start a test to install a wincc v4 project on an win2000 application (this is possible for wincc v5).
For an upgrade from Wincc ver. 4 to ver. 6 you'll first need to migrate to v. 5.1 SP2, then you'll need to update the Sysbase en then migrate to ver. 6 and higher. Is migration a good option in this case??? New software??? Hmmmmm....choises.
After the test I'll post the results.
Similar Topics
So I am working on a machine where the PC has died.
The PC was running Windows XP, Protool RT, Step7 V5.3, SimoComU and other software.
The...
Hi
I need some help!! Siemens Simatic Net 2006 cp5611 has been discontinued, I have a PC with a dodgy hard drive so looking to do a new install...
Hi!
I must communicate two CP5611(master-master) cards trought PROFIBUS ,but i have to use different driver than STEP7.
I just found a citect...
Hi,
I`m looking for purchase a CP5611 (6GK1561-1AA01). Siemens has stopped selling it, only if you have already they can sell it as spare...
The Siemens Simatic CP 5611 does not start on a VMware virtual machine, with Windows XP SP3, installed on a Field PG M3.
It gives an error: "...
