ahargrave
Member
I apologize if I've missed an existing thread on this topic. I have added a siemens rack to replace a Beckhoff remote IO rack and all is well except the analog card (331-7HF01-0AB0)
The Beckhoff addressing:
CH 0-1 PIB320 ,
CH 2-3 PIB323 ,
CH 4-5 PIB326 ,
CH 6-7 PIB329
Siemens card will only allow me to enter starting address as 320.Im fairly new to Siemens and could use some help with this issue. My question is: Can this module be wired to have these addresses be active or do I need to readdress these in project.
attached is a copy of current wiring.
CH 0-1 & CH 2-3 2wire (D)
CH 4-5 & CH 6-7 4wire (C)
Thank you for any help
The Beckhoff addressing:
CH 0-1 PIB320 ,
CH 2-3 PIB323 ,
CH 4-5 PIB326 ,
CH 6-7 PIB329
Siemens card will only allow me to enter starting address as 320.Im fairly new to Siemens and could use some help with this issue. My question is: Can this module be wired to have these addresses be active or do I need to readdress these in project.
attached is a copy of current wiring.
CH 0-1 & CH 2-3 2wire (D)
CH 4-5 & CH 6-7 4wire (C)
Thank you for any help