Hi All,
I need to dispaly an alarm whenever communication link between Simatic multipanel HMI and GE90-30 PLC is failed. There is a system event "Connection to PLC interuppted" in the WinCC Flexible which will be displayed when communication is failed but will be dispalyed for few second only on alarm page. This event does not required acknowledgement and will disappear from alarm screen in few seconds.
I need to configure an alarm for "Communication Failure" such that it remains on the screen until somebody acknowledges it.
All the helps and advice are appreciated.
Thanks
I need to dispaly an alarm whenever communication link between Simatic multipanel HMI and GE90-30 PLC is failed. There is a system event "Connection to PLC interuppted" in the WinCC Flexible which will be displayed when communication is failed but will be dispalyed for few second only on alarm page. This event does not required acknowledgement and will disappear from alarm screen in few seconds.
I need to configure an alarm for "Communication Failure" such that it remains on the screen until somebody acknowledges it.
All the helps and advice are appreciated.
Thanks