Hello, I am having some trouble trying to use Port 2 on the direct logic (250-1) for K-sequence. I am trying to use RS-232, I have a breakout board with the TX, RX, and GND pins wired from the 15 pin dsub to the DB9, matched all protocol settings but I still have no luck.
Port 1 works no problem, however I am trying to use this port 2 for on site testing as it is the only port available outside of where the PLC is located.
Port 1 works no problem, however I am trying to use this port 2 for on site testing as it is the only port available outside of where the PLC is located.
