Hello all,
Some of you might remember a few weeks ago I was working on adding a bar code reader to a DL06. After some time and help from this forum and AD's tech, I have it worikng very well. I decide today to move the data to some different locations within the PLC. I was bringing the data in using the AIN instruction with a data destanation of V2000. I changed that to V12000. Now it does not work. Any suggestions? I looked at the memory map and thought this was a valid location to use, but maybe not.
Thanks,
Micheal
Some of you might remember a few weeks ago I was working on adding a bar code reader to a DL06. After some time and help from this forum and AD's tech, I have it worikng very well. I decide today to move the data to some different locations within the PLC. I was bringing the data in using the AIN instruction with a data destanation of V2000. I changed that to V12000. Now it does not work. Any suggestions? I looked at the memory map and thought this was a valid location to use, but maybe not.
Thanks,
Micheal