I'm working with a MicroLogix 1400 controller (RSLogix Micro) and pulling some registers from several different Modbus RTU devices through Channel 0. I am using the MSG command to do this.
My question is, what is the best way to do this when you have both multiple devices and multiple chunks of registers to pull? I'm going to have 11 MSGs to send when it's all said and done...
I would think that the best way to do this is to wait x, do MSG 1, wait x, do MSG 2, wait x, do MSG 3, etc. i.e. spread the MSGs out evenly across a set period of time. Is this correct?
Any suggestions in general? Thanks
My question is, what is the best way to do this when you have both multiple devices and multiple chunks of registers to pull? I'm going to have 11 MSGs to send when it's all said and done...
I would think that the best way to do this is to wait x, do MSG 1, wait x, do MSG 2, wait x, do MSG 3, etc. i.e. spread the MSGs out evenly across a set period of time. Is this correct?
Any suggestions in general? Thanks