panic mode
Member
Hi everyone,
Just thought to pick your brains:
We have small application where small actuator is required to extend or retract pin to lock two frames.
Normally this would be done by cylinder but unfortunately, this is out of question in this case,
the actuator has to be electric but we don't really want to go for linear servo or robo cylinder.
An ideal candidate:
- stroke of about 1 inch (25mm)
- force of 150N or so should be ok
- speed is not critical (up to 10-15sec is ok)
- should be compact (about 3"x3"x3" or smaller of possible)
- panel space is at premium so anything without drive/controller would be huge plus
- either AC or DC powered - prefereably DC (could be stepper)
- delivery 3-weeks (or better)
Any suggestions?
Just thought to pick your brains:
We have small application where small actuator is required to extend or retract pin to lock two frames.
Normally this would be done by cylinder but unfortunately, this is out of question in this case,
the actuator has to be electric but we don't really want to go for linear servo or robo cylinder.
An ideal candidate:
- stroke of about 1 inch (25mm)
- force of 150N or so should be ok
- speed is not critical (up to 10-15sec is ok)
- should be compact (about 3"x3"x3" or smaller of possible)
- panel space is at premium so anything without drive/controller would be huge plus
- either AC or DC powered - prefereably DC (could be stepper)
- delivery 3-weeks (or better)
Any suggestions?