zachary.wilson
Member
Howdy Everyone,
We have an old machine that uses elipse scada for the hmi, and has a slc 5/05 plc,there was a bit getting stuck on from the hmi, and i finally found it. Below is the bit, it ties to B3:1/7 in the plc, it lines up with the last number in N1, n3, and n4. I have checked this on multiple bits that i know for a fact of what they do and its all the same setup. My question is what is the first three numbers in N1, and what is N2 doing. Different tags in the hmi program have different numbers especially in N2, and is the N1 really start at 1000 instead of 0 for output 1001 instead of 1 for inputs and so on and so on. Thank you for any help. Its only a few older machines most of our machines are either siemens or factory talk. So i don't have much exposure to this one. thank you.
We have an old machine that uses elipse scada for the hmi, and has a slc 5/05 plc,there was a bit getting stuck on from the hmi, and i finally found it. Below is the bit, it ties to B3:1/7 in the plc, it lines up with the last number in N1, n3, and n4. I have checked this on multiple bits that i know for a fact of what they do and its all the same setup. My question is what is the first three numbers in N1, and what is N2 doing. Different tags in the hmi program have different numbers especially in N2, and is the N1 really start at 1000 instead of 0 for output 1001 instead of 1 for inputs and so on and so on. Thank you for any help. Its only a few older machines most of our machines are either siemens or factory talk. So i don't have much exposure to this one. thank you.