Emerson Liebert Ups Gtx2

johnmck66

Member
Join Date
Aug 2007
Location
Manchester
Posts
96
Help, I need the idiot page - with the LED error codes and general startup procedure etc. I have 3 of these things driving me insane at present. I have new batteries on the way - but I can never remeber the codes since someone nicked our manual.
 
johnmck66 said:
Help, I need the idiot page - with the LED error codes and general startup procedure etc. I have 3 of these things driving me insane at present. I have new batteries on the way - but I can never remeber the codes since someone nicked our manual.

I assume you actually meant GXT2 ?

Tech Support 00-80011554499

(In states I assume, but sure they will help!)

Or manual here :)

http://www.eu.emersonnetworkpower.com/EnpSite/viewDocument.cfm?table=document&key=iddocument&id=818

3.4Mb, but very slow.

Hope that helps somebody living on the wrong side of the Pennines ;)
 
Last edited:
Never expected a reply from ullygully land - but thanks a lot - I take me flat at off te yer. Seriously Ta.

Nowt wrong wi pennines - keeps east wind off us.
 

Similar Topics

Does anyone know if it is possible to create a help file that would, when a user presses F1, bring up a custom help (that I made) about my...
Replies
2
Views
124
Two questions for GE/Emerson e.g. PACSystemsRX3i (CPE330): 1. Is it possible to use 2D arrays inside a function as a local member? (I can only...
Replies
0
Views
108
gents, I am trying to configure communication with EMERSON PK300 controller through port A1 using generic ethernet communication module . I could...
Replies
0
Views
144
Hi there, I'm doing some extensive testing and commissioning with a slew of new Emerson PACSystems RX3i PLCs. It would be convenient to...
Replies
5
Views
209
Hi there, Trying to get some ascii serial communications working via RS485 (COMMREQ functions). I have attached our wiring for the COM2...
Replies
1
Views
1,015
Back
Top Bottom