busarider29
Lifetime Supporting Member
I have a SLC 5/05 and I am having difficulties establishing comms to it via RS232. I have a 1747-UIC USB to RS232/DH485 converter that I am using. Comm port on my laptop is COM-9 and I have verified in Device Manager and RSLinx (configure drivers). The "USB" and "OK" led's on the 1747-UIC are lit up solid green. I clicked the "Auto Configuration" button and it does its thing and comes back with "Auto Configuration Successful!".
These are the settings that are set after the Auto configuration completes:
Comm port: COM 9
Device: 1770-KF3/1747-KE
Station Number: 00
Parity: Even
Error Checking: CRC
Stop Bits: 1
Protocol: Full Duplex
I have tried changing the parity and the baud rate with no change in result. Still can't see processor in RSLinx. This is a processor that I received via surplus and I need to configure the IP address for it and dump my program to it.
Any help is appreciated.
These are the settings that are set after the Auto configuration completes:
Comm port: COM 9
Device: 1770-KF3/1747-KE
Station Number: 00
Parity: Even
Error Checking: CRC
Stop Bits: 1
Protocol: Full Duplex
I have tried changing the parity and the baud rate with no change in result. Still can't see processor in RSLinx. This is a processor that I received via surplus and I need to configure the IP address for it and dump my program to it.
Any help is appreciated.