coopdegrace
Member
Hi all,
I was hoping someone could please give me a hand.
I have done a project on FactoryTalk View release 6.10 using a Panel View Plus 600 communicating to a ControlLogix PLC via Ethernet.
I have a bunch of alarms that are activated under various conditions. What I would like to do is make the alarm jump to button on my main page blink when there are active alarms that are not acknowledged. When they have all been acknowledged then I would like it to stop until such time that a new alarm appears. I assume I need to to use an all alarms acknowledged bit to trigger the button to flash but I am not sure how to do it.
If anyone could help this would be much appreciated.
Thanks
I was hoping someone could please give me a hand.
I have done a project on FactoryTalk View release 6.10 using a Panel View Plus 600 communicating to a ControlLogix PLC via Ethernet.
I have a bunch of alarms that are activated under various conditions. What I would like to do is make the alarm jump to button on my main page blink when there are active alarms that are not acknowledged. When they have all been acknowledged then I would like it to stop until such time that a new alarm appears. I assume I need to to use an all alarms acknowledged bit to trigger the button to flash but I am not sure how to do it.
If anyone could help this would be much appreciated.
Thanks