Burnavator
Member
I have an issue on my vessel, we have water tight door system created in China, company is no longer operating. We have 7 doors each with their own Fatek PLC which operates the door and they are all connected to a display unit on the bridge A board with leds and buttons etc (not a HMI), (this also has a remote close function. and another panel in the Engine Room for displaying door status etc. Much the same as the bridge unit but without the remote close function. We have a backup of all the existing PLC code for the door but the bridge and Engine room PLCs are password protected and no way to get the password. I have created the PLC code for the door and set up all the links in the Link table, Ive double checked all of this and it should be correct however it doesnt appear to working as expected, Im sure its just something wrong with the communication setup between the PLC's. All the doors are the same PLC code only the station ID's are changing doors 1-7 = station ID 1-7 Engine room PLC = 8 and bridge PLC station ID 9.
I have attached all of the software with my new Bridge PLC code =9
Can someone please take a look and see what the issue is ive made with the comms.
Thank you very much in advance
Brendan
I have attached all of the software with my new Bridge PLC code =9
Can someone please take a look and see what the issue is ive made with the comms.
Thank you very much in advance
Brendan