sorry for not giving enough inform last time , lm doing this question see below at the moment and i am only getting used to plc programing.i have the x movement solve and the floating point for Y done but i dont know where to put the outputs
A fixed position plasma cutter is used to cut a circle of diameter 2m from a flat steel
plate by moving the bed to which the plate has been bolted.
The X and Y movements of the bed are controlled by two servo-driven motors.
The co-ordinates for the centre of the circle are x ¼ 2:5m, y ¼ 2m. Produce a ladder
diagram program, which will enable the plate to be cut.
Hint: Let the distance the bed moves be incremented a distance of 50mm every 0.1 sec
from its datum position (0, 0) to its maximum value and then decremented 50mm
every 0.1 sec back to the datum position. The corresponding Y movement being
determined, using Pythagoras theorem.