FTView- Cognex InSight Display Control

[splendid87]

Hi All,

I cant find Cognex InSight Display ControlActiveX at FTView.

May I know where to get cognex ocx file?

 

[Dravik]

It is installed as part of the Insight installer, I would recommend choosing to install the sample projects as well, very helpful for setting it up.

The controls themselves are usually located in C:\Program Files\Common Files\In-Sight\%version%

 

[splendid87]

It is installed as part of the Insight installer, I would recommend choosing to install the sample projects as well, very helpful for setting it up.

The controls themselves are usually located in C:\Program Files\Common Files\In-Sight\%version%

Thanks bro.

I found CvsInSightDisplay.ocx file and installed Display Control Sample project.

 

[splendid87]

I faced another problem.

I run FactoryTalk View on my laptop which can see the barcode images.

I cant see the barcode image if I run on Panelview Plus 7(HMI).
Alert message that "unable to load ActiveX control for display"

 

[Dravik]

The Cognex activex controls aren't installed on the Panelview.

Now, i'm not sure they CAN be, but you are probably going to need to reach out to Cognex and/or Rockwell to find out.

Offhand, I know that the Cognex VisionView software CAN be installed on a performance panelview 7, there's a knowledge base article I recall seeing once upon a time.

 

[splendid87]

The Cognex activex controls aren't installed on the Panelview.

Now, i'm not sure they CAN be, but you are probably going to need to reach out to Cognex and/or Rockwell to find out.

Offhand, I know that the Cognex VisionView software CAN be installed on a performance panelview 7, there's a knowledge base article I recall seeing once upon a time.

VisionView manual wrote that for Panelview 7 standard only.
Is it performance work as well?

 

[splendid87]

I installed VisionView on the Panelview 7 performance but it alert message that "cant find an Entry Point 'StartDSSPDispatcher' in a PInvoke DLL 'CogPlatform.dll'."

 

[ipaqbxs]

In case anyone else still needs this, I was able to solve the "cant find an Entry Point 'StartDSSPDispatcher' in a PInvoke DLL 'CogPlatform.dll'." problem by using the x86 VisionView installer instead of the ARM.