Davev2005
Member
Hello All.
We're working with a GE 305 Pac controller with a IC695PNC001 profinet controller card to communicate with a Fanuc Robot thru Profinet (robot as IO device).
The robot side was no problem following his manual for the configuration and we use a Siemen 1200 PLC to do it.
The problem is on IC695PNC001 side, we can't stablish comms with the robot.
We try all ways without any luck.
Asking to the supplier and he said that is not possible do it with IC695PNC001, but i'm not sure about.
Any help are welcome!
Regards
Dave
We're working with a GE 305 Pac controller with a IC695PNC001 profinet controller card to communicate with a Fanuc Robot thru Profinet (robot as IO device).
The robot side was no problem following his manual for the configuration and we use a Siemen 1200 PLC to do it.
The problem is on IC695PNC001 side, we can't stablish comms with the robot.
We try all ways without any luck.
Asking to the supplier and he said that is not possible do it with IC695PNC001, but i'm not sure about.
Any help are welcome!
Regards
Dave