NetNathan
Lifetime Supporting Member
Why does GE RX3i insist that the inputs (%I) be retentive?
I edited the variable declaration table for all the inputs to be non-retentive. It loaded without fault....THEN.... when I did a "Validate" it changed all of them back to Retentive??
Error on each input said that the "Memory Area Must Be Retentive changing to Retentive"??
Why would inputs have to be retentive??
Some %I references I use in my logic may not be directly connected to input module.
I guess I will have to use a first scan bit to set all my %I bits to "0"?
I edited the variable declaration table for all the inputs to be non-retentive. It loaded without fault....THEN.... when I did a "Validate" it changed all of them back to Retentive??
Error on each input said that the "Memory Area Must Be Retentive changing to Retentive"??
Why would inputs have to be retentive??
Some %I references I use in my logic may not be directly connected to input module.
I guess I will have to use a first scan bit to set all my %I bits to "0"?
Last edited: