jcraft
Member
HI all,
Question regarding a program in Versapro. BEar with me as I just do basic programming updates and troubleshooting. THis program is on a machine and has been in operation and running for years. Operator had an issue with machine freezing up and they rehomed . Part of the system would not home and was froze. Going into the program there was a rung that has to be set in order for the rest of the system to home. The rung has a set coil in it ( %m13), all the conditional bits in the rung were true however the bit was not turning on. I forced on and the machine homed normal. I unforced and downloaded program again but this didn't help. So I went in and re-addressed the %M13 bit to %m3535 and re-downloaded. This worked and the machine homed as it should. I went back in just to see and re-addressed it back to %m13 and it also worked again. Any ideas why a memory location would freeze like this. Also when looking at the rungs for the reset coil. it shows the reset coil on ( in red) even though the rung is not true for the reset coil. Shouldn't the resett coil only come on when the rung is all true. MAybe someone can touch on that. Thanks
Question regarding a program in Versapro. BEar with me as I just do basic programming updates and troubleshooting. THis program is on a machine and has been in operation and running for years. Operator had an issue with machine freezing up and they rehomed . Part of the system would not home and was froze. Going into the program there was a rung that has to be set in order for the rest of the system to home. The rung has a set coil in it ( %m13), all the conditional bits in the rung were true however the bit was not turning on. I forced on and the machine homed normal. I unforced and downloaded program again but this didn't help. So I went in and re-addressed the %M13 bit to %m3535 and re-downloaded. This worked and the machine homed as it should. I went back in just to see and re-addressed it back to %m13 and it also worked again. Any ideas why a memory location would freeze like this. Also when looking at the rungs for the reset coil. it shows the reset coil on ( in red) even though the rung is not true for the reset coil. Shouldn't the resett coil only come on when the rung is all true. MAybe someone can touch on that. Thanks