psychosunshine
Member
I have an HMI project for a GT1675M-STVA GOT HMI, that will be communicating with a Mitsubishi Q06HCPU through a QJ71E71-100 Ethernet card.
How do you configure the Ethernet settings in the HMI project and in the PLC to get it to talk?
I do see in the settings where to set the IP address. And there is a default UDP port of 5001. But, I do not know what the Host, N/W number or the PLC number should be set at.
Also, are there any important settings in the Gateway Configuration?
Any help is appreciated...
How do you configure the Ethernet settings in the HMI project and in the PLC to get it to talk?
I do see in the settings where to set the IP address. And there is a default UDP port of 5001. But, I do not know what the Host, N/W number or the PLC number should be set at.
Also, are there any important settings in the Gateway Configuration?
Any help is appreciated...