Help with old WinCC R4 License (Softnet-PG)

Lare said:
No labre here.
Click to expand...

Damn I misread that one.

Thanks I will see if I can get it transferred from the disk correctly. Strange that it says it's an active license surely that would say invalid or something to that effect if it's not happy with it.
 
SigmaDelta - You where spot on with the license. I have now applied it correctly and the pop up is gone. Thank you for pointing me at the correct licesene file.
 

Similar Topics

T
Anyone here work for Johnson Controls now or in the past?...need help with OLD PLC program
I have an old Sentry Palletizer (S/O Number 3007 / Serial Number 1172) that has lost its program as the backup battery died years ago. I can...
Replies
0
Views
161
TheCaptain2000
T
G
Urgent help needed: old Telemecanique/Modicon/Schneider Electric (TSXP5710). Will compensate anyone who can assist!
I have an old PLC (circa 2007) consisting of Telemecanique/Modicon/Schneider Electric devices. The system has developed errors and unfortunately...
Replies
2
Views
298
greekgremlin
G
C
Help with old CUTLER-HAMMER D100 Programmable controller
Hi everyone, I know this is an old one but we have a d100 in our wrapper , it just stopped working. When the inputs are pressed the corresponding...
Replies
3
Views
253
carlos1984
C
A
UniOP Designer Software - Old Need Help
Hi I have an old Exor Tline HMI that requires an older version of UniOP Designer. I reached out to Exor but they no longer support this older...
Replies
2
Views
1,248
Bob KP techniek
B
A
OLD PLC Help
Does anyone know what kind of PLC this is, what software and cable I would need to upload the program? I have been asked to upgrade it. Thanks Mike
Replies
5
Views
2,981
NetNathan
N
Back
Top Bottom