R-110
Member
Hello,
There was a mix up in information on some redeployed equipment and two of the micro 1400's that came in were hooked to 120v when they should've been 24v. I have changed the fuse on the power board on one of the micros but that still didn't get it to power up. Has anyone else repaired a unit after an incorrect voltage was used? How did you end up getting it to work?
Thank you.
There was a mix up in information on some redeployed equipment and two of the micro 1400's that came in were hooked to 120v when they should've been 24v. I have changed the fuse on the power board on one of the micros but that still didn't get it to power up. Has anyone else repaired a unit after an incorrect voltage was used? How did you end up getting it to work?
Thank you.