Hello all,
I have a SLC 500 and I have been learning a lot.
Everything starts from LAD2
I have created a few more ladders:
LAD2 - MAIN
LAD3 - CAM
LAD4 - SLIDER
........
Using ladders allows me to organise the program and really focus on getting this right.
Here is the problem, which I think is simple however, I am not sure.
I know that sub routine must be used to jump between ladders. The issue is that LAD 3, 4, .... all work independently.
My question is, can you have all the ladder scanned at the same time. I would like to have about 40+ ladders and they all work independently with out the need of the other ladders.
I hope I am explaining it well.
Thank you
I have a SLC 500 and I have been learning a lot.
Everything starts from LAD2
I have created a few more ladders:
LAD2 - MAIN
LAD3 - CAM
LAD4 - SLIDER
........
Using ladders allows me to organise the program and really focus on getting this right.
Here is the problem, which I think is simple however, I am not sure.
I know that sub routine must be used to jump between ladders. The issue is that LAD 3, 4, .... all work independently.
My question is, can you have all the ladder scanned at the same time. I would like to have about 40+ ladders and they all work independently with out the need of the other ladders.
I hope I am explaining it well.
Thank you
Last edited: