KingPresident
Member
I have a vector drive faulting out. Manual says inspect and test the Braking Resistor. I have never done this procedure before.
===
From Google searching I came up with:
1. remove resistor from circuit.
2. set fluke to ohms, put a probe on each end of the resistor
3. compare values of meter and resistor rating.
===
Is that correct?
===
From Google searching I came up with:
1. remove resistor from circuit.
2. set fluke to ohms, put a probe on each end of the resistor
3. compare values of meter and resistor rating.
===
Is that correct?