hsc micrologix 1000
- Thread starter hanyrag
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
For reference, you will need the MicroLogix 1000 User Manual:
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1761-um003_-en-p.pdf
The MicroLogix 1000 HSC is very old and simple compared to the modern Micrologix. Essentially you just use the C5:0 counter element with the first inputs on the controller and define some registers for an interrupt. There is an entire chapter in that user manual dedicated to the HSC.
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1761-um003_-en-p.pdf
The MicroLogix 1000 HSC is very old and simple compared to the modern Micrologix. Essentially you just use the C5:0 counter element with the first inputs on the controller and define some registers for an interrupt. There is an entire chapter in that user manual dedicated to the HSC.
kunal07
Member
Hi everyone,
I have connected my micrologix 1000 with an encoder but it is giving me a negative value.
I really need help to sort this out
I have connected my micrologix 1000 with an encoder but it is giving me a negative value.
I really need help to sort this out
Similar Topics
Dear all
I want to configure 660 ppr encoder to micrologix 1000 I used HSC instruction as per help I turned on C5:0/UA bit on, but I am not...
I am setting up a compact and low cost machine that will dose between 15 and 60 ml of liquid depending on the setpoint the user inputs. I have set...
Hi, everyone I’m working on a registration project where I’m counting encoder pulses between registration marks. I’m expecting to see around 1800...
I am trying to program a Micrologix 1400 to control a beer keg filler using an IFM SM6001 flow meter. The meter will be set up for a pulse...
Is it possible to set up the HSC in the 1766-L32BXB as a ring counter.
So it will roll over to 0 counting up and continue to count up that...