commcorresp
Member
Is this an appropriate place to ask a question about Phil Melore's PLC simulator?
It looks like a nice platform for a novice to try out some simple LD programming. But I can't get it to work as expected.
Flash Player presents the image fine. Help files work fine. Can add rungs and instructions. Looks like I can save to Server. But ...
When I put it into continuous Run, input On state does not get reflected in relay contact. Also, when reopen file after save to Server, contacts and coils have "?" instead of the inputs and outputs that had been assigned.
Feels like it must be a browser issue. I'm using Chrome on Windows 10. Did have to make sure Flash Player was enabled before getting off of first base. That's OK now. But there must be something else wrong
Any suggestions would be appreciated.
It looks like a nice platform for a novice to try out some simple LD programming. But I can't get it to work as expected.
Flash Player presents the image fine. Help files work fine. Can add rungs and instructions. Looks like I can save to Server. But ...
When I put it into continuous Run, input On state does not get reflected in relay contact. Also, when reopen file after save to Server, contacts and coils have "?" instead of the inputs and outputs that had been assigned.
Feels like it must be a browser issue. I'm using Chrome on Windows 10. Did have to make sure Flash Player was enabled before getting off of first base. That's OK now. But there must be something else wrong
Any suggestions would be appreciated.