Rob735
Member
Hello All,
First off I want to admit I think I am in a bit over my head and need help.
I have been thrown into a customers plant with a crashed Inetllution FIX32 system, and was given a "new" PC to install all the software onto and "just connect the cables and it will work."
I'm not completely new at this and knew it was not going to be that easy but hey crossed my fingers and wished for the best. To my surprise I was able to get all the software and the recovered files installed on the "new" windows 2000 computer I was given.
I have connected the PLC to the serial port and am able to see the PLC on RSLogix however when I try to run Intellution FIX View, I am getting and error Stating the Connection is NOT established with Node.
I have taken a few educated guesses to no success, so if anyone has information to help me out with this i would greatly appreciate any and all help.
also I have searched past forums but have not had success on finding this issue.
Thank you for your responses in advance.
Rob
First off I want to admit I think I am in a bit over my head and need help.
I have been thrown into a customers plant with a crashed Inetllution FIX32 system, and was given a "new" PC to install all the software onto and "just connect the cables and it will work."
I'm not completely new at this and knew it was not going to be that easy but hey crossed my fingers and wished for the best. To my surprise I was able to get all the software and the recovered files installed on the "new" windows 2000 computer I was given.
I have connected the PLC to the serial port and am able to see the PLC on RSLogix however when I try to run Intellution FIX View, I am getting and error Stating the Connection is NOT established with Node.
I have taken a few educated guesses to no success, so if anyone has information to help me out with this i would greatly appreciate any and all help.
also I have searched past forums but have not had success on finding this issue.
Thank you for your responses in advance.
Rob