RockyLeafs
Member
Hello,
We have a new project using 12 (yes, 12...) KEB servo drives.
We haven't ever used this drive yet, so I'm having some challenges to getting it to communicate to the AB PLC (L33ER) over Ethernet/IP.
We do have an Ethernet/IP module on the KEB servo.
I seem to have the IP address and can connect to the drive with the Combivis software, but the drive does not show up on RSLinx.
I'm also wondering about the homing method (my hope was to just use a hardstop location, but cant find any clear detail on how to do that in the manual).
Any help from someone with experience using these drives would be greatly appreciated.
We have a new project using 12 (yes, 12...) KEB servo drives.
We haven't ever used this drive yet, so I'm having some challenges to getting it to communicate to the AB PLC (L33ER) over Ethernet/IP.
We do have an Ethernet/IP module on the KEB servo.
I seem to have the IP address and can connect to the drive with the Combivis software, but the drive does not show up on RSLinx.
I'm also wondering about the homing method (my hope was to just use a hardstop location, but cant find any clear detail on how to do that in the manual).
Any help from someone with experience using these drives would be greatly appreciated.