Hi,
I'm trying to change some values of Kinetix 6000 drive via Drive Executive software, but drive doesn't accept them. It shows message
" The drive did not accept value (value, for example 3000) for parameter ... "
Values I tried to insert are within the range so this not the problem. I can insert them only when I'm not connected when Sercos card isn't in Control Logix chasis . Does Sercos card has promary over Drive Executive? Where can I change it ?
Best regards,
Matt
I'm trying to change some values of Kinetix 6000 drive via Drive Executive software, but drive doesn't accept them. It shows message
" The drive did not accept value (value, for example 3000) for parameter ... "
Values I tried to insert are within the range so this not the problem. I can insert them only when I'm not connected when Sercos card isn't in Control Logix chasis . Does Sercos card has promary over Drive Executive? Where can I change it ?
Best regards,
Matt