mike3475 Member M Join Date Feb 2013 Location brooklyn ,NY Posts 334 Aug 5, 2022 #1 Hi, Expert: Is there any possible MAM PC bit turning on before reaching the position? Thanks! Last edited: Aug 5, 2022
mike3475 Member OP M Join Date Feb 2013 Location brooklyn ,NY Posts 334 Aug 5, 2022 #2 just checked the trend, found sometimes PC bit goes high before reaching the position, sometimes PC bit goes high almost at the same time reaching the position.
just checked the trend, found sometimes PC bit goes high before reaching the position, sometimes PC bit goes high almost at the same time reaching the position.
aawilliams85 Member A Join Date May 2021 Location United States Posts 18 Aug 6, 2022 #3 If I recall correctly, the Position Complete bit should be set when the actual position reaches final position within the Lock Tolerance value.
If I recall correctly, the Position Complete bit should be set when the actual position reaches final position within the Lock Tolerance value.
mike3475 Member OP M Join Date Feb 2013 Location brooklyn ,NY Posts 334 Aug 6, 2022 #4 where is setting for lock tolerance? Thanks! Never mind, I found it. Last edited: Aug 6, 2022