Okay I have an Add-on instruction used in 3 different ladders one of the tags (only in the add on's scope) is looking at an analog input card, actually depending on which ladder you are looking at it is looking at 3 different ones that exist on different remote racks.
Here's the questions, first, where does it point to the actual raw data from the input module? it is looking at the correct cards but I cannot determine how it is doing so.
Second, the numbers are scaled but I cannot determine where. Could that info only be available in the offline project? ?????
Here's the questions, first, where does it point to the actual raw data from the input module? it is looking at the correct cards but I cannot determine how it is doing so.
Second, the numbers are scaled but I cannot determine where. Could that info only be available in the offline project? ?????