theDave2
Member
I've got a F1-20P-E hand held programmer attached to a F2-40M PLC and need to read out the program so when this unit goes belly up I can replace it.
The manual for the HHP says to press CLEAR, INSTR, STEP+ to read the elements. When I do this the address readout starts at zero, and only a "K" shows for the instruction and 0 for data, for step 0 to step 150. Got tired of pressing STEP+.
Is there some convention as to where the actual ladder starts ? And how to get there ? When I tried to dial up a step number, the DATA readout changed, not the step #: CLEAR STEP 1 0 0 INSTR did not take me to Step #100, IIRC. Maybe I forgot to press the STEP key.
Tx,
Dave
The manual for the HHP says to press CLEAR, INSTR, STEP+ to read the elements. When I do this the address readout starts at zero, and only a "K" shows for the instruction and 0 for data, for step 0 to step 150. Got tired of pressing STEP+.
Is there some convention as to where the actual ladder starts ? And how to get there ? When I tried to dial up a step number, the DATA readout changed, not the step #: CLEAR STEP 1 0 0 INSTR did not take me to Step #100, IIRC. Maybe I forgot to press the STEP key.
Tx,
Dave