I have searched every where but cant seem to find the answer. Is the DC COM terminal on a Micrologix 1000 controller internally connected to the inputs?
I'm wanting to install a pnp sensor and the manual request you take a jumper from the 0vdc(-24) from the 24 volt power supply and land it on the DC COM terminal.
I'm trying to understand why and what is it doing? Thank you
I'm wanting to install a pnp sensor and the manual request you take a jumper from the 0vdc(-24) from the 24 volt power supply and land it on the DC COM terminal.
I'm trying to understand why and what is it doing? Thank you