theDave2
Member
Can I use RSLogix 500 v4.5 to program a 1200 series C ? I only can select series A or B processor in RSLogix 500. I don't need any of the series C processor new stuff, it's a new blank one. I'm presuming it's a C, but who knows.
Also, can I use directly (from notebook serial port) the 1761-CBL-PM02 cable, not using a UIC / AIC / whatever module ?
Oh, this is urgent 'cause I'm asked to drive 2.5 hours tomorrow to put in a quick program that I'm writting tonight.
Tx,
Dave
Also, can I use directly (from notebook serial port) the 1761-CBL-PM02 cable, not using a UIC / AIC / whatever module ?
Oh, this is urgent 'cause I'm asked to drive 2.5 hours tomorrow to put in a quick program that I'm writting tonight.
Tx,
Dave