fredjohns
Member
We have a small machine that has an Allen Bradley Micrologix 1000 controlling it. Its been running for about 5 years trouble free. Today they had a problem that the machine would not run and when we checked, the Fault light on the Micrologix was blinking. Turning off the machine and restarting it would not clear the fault so we hooked up the laptop and cleared it using the RSLogix 500 software. The message that showed up was as follows:
MINOR ERROR AT THE END OF SCAN
REFER TO S:5
We were able to clear the fault and everything is back up and running. Is there anyway to determine what actually caused the fault or something we should look for if it happens again.
Thanks
Fred
MINOR ERROR AT THE END OF SCAN
REFER TO S:5
We were able to clear the fault and everything is back up and running. Is there anyway to determine what actually caused the fault or something we should look for if it happens again.
Thanks
Fred