Mitsubishi PLC - CCLink I/O configuration

[rajivs1107]

friends,
I am using Q06H CPU, and CClink QJ61BT11N . I want to add a servo drive of DYNASERV that uses 64 I/O using CClink . in my CPU 1 to 34 stations are already configured . i want to use station number 35 and 36 (32 remote i/o to each) for this DYNASERV . I set it in parameter but if i do loop test it only shows station number 35 but doesn't show station number 36 when i do loop test . please help how to configure this servo drive .

 

[rajivs1107]

can anyone help - please

 

[rajivs1107]

friend please help on this if you know....thanks in advance

 

[baref00t25]

Unfortunately there isn't much help here with the Mitsubishi stuff, not many of us know it. Sorry. I've posted a couple questions that have gone unanswered as well. Your best bet is to contact a Mitsubishi distributor in your area.