Hi everyone,
I setting a PTO instruction with different Accel/Decel in ML1400 (ADI=1). According to the manual:
“If separate acceleration and deceleration profiles are desired, you must choose a long integer file number and a starting element. There must be four long elements available in the file”
“ADP-Accel/Deccel Pulses or File:Elem, If ADI=1”
I chose a four element Long integer data file (“Element 1: Acceleration Count,Element 2: Deceleration Count, Elements 3 and 4: Reserved”) and I make sure that the number of pulses are correct ( “the maximum ADP value that may be entered without causing a fault [(PTOX:0.TOP/2) -2]”). I tried to copy the file using a CPW instruction and a MOV, it didn’t work. Error code -3
“Acceleration Count and Deceleration not defined during going to run mode when Accel/Decel Pulses Independent (ADI) is set (1).”
What should be entered in the function file ADP? Or how should I enter a reference to the four long element integer file?
I setting a PTO instruction with different Accel/Decel in ML1400 (ADI=1). According to the manual:
“If separate acceleration and deceleration profiles are desired, you must choose a long integer file number and a starting element. There must be four long elements available in the file”
“ADP-Accel/Deccel Pulses or File:Elem, If ADI=1”
I chose a four element Long integer data file (“Element 1: Acceleration Count,Element 2: Deceleration Count, Elements 3 and 4: Reserved”) and I make sure that the number of pulses are correct ( “the maximum ADP value that may be entered without causing a fault [(PTOX:0.TOP/2) -2]”). I tried to copy the file using a CPW instruction and a MOV, it didn’t work. Error code -3
“Acceleration Count and Deceleration not defined during going to run mode when Accel/Decel Pulses Independent (ADI) is set (1).”
What should be entered in the function file ADP? Or how should I enter a reference to the four long element integer file?