Modbus conversion Micrologix 1100 to Contrologix Prosoft MVI56

Hi Ken ,
Dont' bother urself , i know it's very hard job to de reverse _engineering ,that's why i wanted to workaround by using the ACL .

I think i'm going to use ch0 (command or messages pending)System bits to trigger that ACL and see what happens .:)

Thanks again
•
 

Similar Topics

F
IEEE754 conversion - 32 bit - Modbus TCP
Hi, Im doing a project with a Power meter that offers Modbus TCP and each signal is a 32bit Float.¨ I tested the float in Modbus Poll and...
2
Replies
22
Views
3,087
drbitboy
drbitboy
V
Redundant AB CLX with Modbus conversion
Hi Guys, Maybe you have some experience with this set-up and can give me some pointers. Project is to use an Emerson DCS to communicate (via...
Replies
3
Views
2,040
Contr_Conn
Contr_Conn
O
DF1 to Modbus address conversion
I have an existing Micrologix 1400(B) which is being addressed from an HMI via a PCCC/DF1 driver. However in moving to a new HMI I want to use a...
Replies
6
Views
2,072
bernie_carlton
bernie_carlton
S
Modbus conversion for Baseline-MOCON
I am working on a Scada project where the device (a Hydrocarbon Detecting equipment) have a RS-232 port for serial interface. But you can only...
Replies
2
Views
1,683
s7xp.com
s7xp.com
H
DNP3 to PLC conversion (modbus)
I need to replace legacy RTU's with PLC's or other devices that will act as a slave in communicating DNP3 with a master. We must communicate DNP3...
Replies
2
Views
4,528
Laurent
L
Back
Top Bottom