We've been migrating to Studio V32. When invoking the Motion Direct dialog box, there is a a delay of 30 seconds to 2 minutes before the dialog pops up. With our previous Logix V24, response was much quicker. Has anyone else found this to be an issue? Thanks!
Motion Direct commands sluggish in V32
- Thread starter Square1
- Start date
Similar Topics
We have a customer wanting us to quote a welding line using only automation direct CPU for servo controls. We are traditionally a Siemens and AB...
Has anyone used an Automation Direct MB-Gateway modbus tcp to rtu gateway on a MicroMotion RFT9739 transmitter? We are able to get modbus rtu...
Hello Chaps,
Has anyone come across Elau Motion controllers communicating to a Wonderware SCADA via the Siemens L1Direct protocol?
We have a...
Hi all, I have an application involving 3 axis motion.Normally we would use AB but i have been asked to consider Direct logic. Has anyone used...
I've been fighting with a Micromotion 1700. Can't get into the configuration area. It's as if the optical sensors are disabled or locked out...